home sitemap English
About US
제품 구매문의
RecurDyn 기술사이트
버전 히스토리
서비스팩 다운로드
학생버전 다운로드
제품 브로슈어
한양대학교에 RecurDyn 소프트웨어
펑션베이, 2018 Annual Meeting 평
펑션베이(주), CTI Symposium에 참
MBD for ANSYS 교육 (난징, 중국/1
2017 RecurDyn Users Day (서울 양
2017 RecurDyn Users Day를 개최합
2017 독일 RecurDyn TechnologyDay
   Customization Hydraulic
   Design Optimi...
   AutoDesign MTT2D, MTT3D
The contact normal force is calculated by ...
fbadmin(admin) Date: | Read : 11726

The contact normal force is calculated by . Then, if the damping exponent(m2) and indentation exponent(m3) were not checked as same as default setting, what value would be used for those parameter? I suppose it would be m2=m3=zero. Is it correct?
A) No! If you unchecked the damping exponent(m2) and indentation exponent(m3), RecurDyn uses a default value as following: M2=1 M3=0 So, contact normal force formulation is .


    Prev : Could you tell me what is the meaning of negative/positive sign for plotting friction force? I guess like this: if it is negative, friction force works to the direction to stop sliding motion.
    Next : During the simulation of contact problem model, the time step was always 5.0E-4sec. But the defined Maximum Time Step was 1.0e-2sec. Why the time step doesn't become shorter than 5.0e-4sce?